| Frequently
Asked Questions About Surface Supplied Air. (SSA)
1. Q. What exactly is the concept of SSA?
A. Air from a low-pressure compressor at the surface
pumps air through a hose and demand second stage regulator system
directly to the divers below. Virtually no gear is worn and the divers
have a lifeline to the surface with the hose system and a simple belt
that secures the hose and regulator to the body.
2. Q. How long will the engines run?
A. Running time on the smaller AL-R260 is at least two
hours on 1-1/2 quarts of gas. Longer on Model AL-C360 which has a three
quart tank.
3. Q. Do the motors require an oil gas mix?
A. No. They are four-cycle engines and take straight
gas of unleaded 87 to 89 Octane.
4. Q. Are the compressors oil lubricated?
A. No. A teflon cap on an aluminum piston
"waves" inside the cylinder sleeve precluding the need for
even rings and seals. Bearings are sealed and grease cannot enter the
breathing system.
5. Q. What keeps exhaust fumes out of the
breathing air?
A. A vertical snorkel draws air in 30 inches above the
compressor. Exhaust is shot away on the opposite side. The way the unit
floats, the exhaust will always seek the down wind position.
6. Q. What depths can I reasonably expect on
an Air Line?
A. The smaller model, AL-R260, will truly support two to
70 feet, three to 40. Model AL-C360 will do three to 70 feet, four to 40
and beyond.
7. Q. What length are the hoses?
A. They are all arbitrarily 60 feet to encourage diving
within no-decompression limits. We will, however, customize lengths for
certain applications such as deck mounting.
8. Q. Won't a salty environment cause the
equipment to rust?
A. It would without a few simple care procedures. When it
is new you would lightly coat all the exposed metal and hardware with a
marine-grade lube/protectant. After the dive day, a fresh water bath
will rinse away accumulated salt, followed by a light touch-up of the
protectant. Wherever possible, stainless steel or nickel-plated brass is
used.
9. Q. Is training needed?
A. Yes. Although easier to use as no gear is worn, you
are still subject to the same physical laws. BCDs are not discouraged
but they are not as critical, as the weight of air in a Scuba cylinder
is not being consumed. Snorkel vests are an option but remember, you are
connected to the surface float through the hose system.
10. Q. If the engine runs out of gas, what
happens?
A. The hoses are under pressure and supply a reservoir of
air for safe, unstressed ascent. You will be aware when the engine stops
as each succeeding breath will require slightly more effort. As you may
know, the air in the hoses will naturally increase in volume as you
rise.
11. Q. Are the floating models stable when
the sea gets choppy?
A. Yes, up to three footers. When you feel a surge on the
hose you will know it's time to call it a day, or at least to go to the
surface to evaluate the situation.
12. Q. Do the floats tow easily?
A. Yes. The divers being free of gear experience the
freedom of snorkelers. Otherwise, the hoses being under pressure will
arch gracefully down so the floats are not being pulled awkwardly. The
task of towing is shared by at least two anyway. They should never be
towed behind a boat except at slow idle. They will sink.
A SPECIAL NOTE
ABOUT DIRECT-DRIVE.
The Air Line has developed and
introduced the lightest and most efficient direct-drive in the diving
market, and as such, owns sole distribution rights of its unique
products.
In the frenzy to capitalize
on the concept, certain other manufacturers are offering compressor
systems used for stapling and nailing in the construction business.
Their premise is that bigger motors make better compressors. They do
not---they make more weight.
|